Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Why Frisco Homeowners Choose Belgard Construction
We provide independent Belgard construction service in Frisco, TX. That means we install, repair, and rebuild Belgard paver patios, paver driveways, retaining walls, and fire features, and we specify the base, drainage, and joint sand that make those systems hold up in North Texas clay and heat. What makes our Belgard work different is that we start at the layer nobody sees. A Belgard hardscape lives or dies on what’s under it.

Frisco is one of the fastest-growing large cities in the country, and almost none of its housing stock predates the 1990s. Most of it went up in the 2000s – 2020s boom. Construction here is overwhelmingly new-build and greenfield, not remodel-and-repair, so most hardscape calls are builder-warranty-era work on subdivisions still being finished around the homeowner, plus constant infill as the last big parcels on the north and west edges get platted.
Mega-Arbel, Catalina, and Weston Stone are names we work with regularly, and we’ll tell you honestly when a repair beats a rebuild. To be clear: we are an independent Belgard service provider. We are not affiliated with, authorized by, or a dealer for Belgard. Call (833) 620-7367 for a free estimate.
Why Trust Construction Frisco for Your Belgard Construction?
Belgard pavers and wall systems are made to a specific dimension and a specific color blend, and that’s what makes them worth installing properly. Get the base wrong and the whole system fights you. Our technicians have up to 11 years of experience with hardscape systems, and they know how Belgard units behave once they’re down over Frisco’s expansive clay.
We use Belgard units and matching components where color and dimensional consistency matter, and quality aftermarket base, polymeric sand, and geogrid that meet or exceed spec where the visible product isn’t the issue. No model line is invented here; we work with what’s actually on the ground.
Warranty-safe practice matters too. Pulling a settled section, re-excavating the base, and resetting the pavers keeps the original Belgard material in place and its color blend intact, which is almost always better than patch-matching new units into an older field. On retaining walls, we check what the wall is actually holding back before anyone lifts a block.
And we’re candid about what causes a failure. If the base was built too thin, a cosmetic fix won’t last a season. We’d rather tell you that up front than sell you a repair that comes back.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Common Belgard Construction Problems We Fix in Frisco
Belgard hardscapes fail the same handful of ways here, and the cause is almost always underneath or between the units rather than in the units themselves.
- Settling and rocking on Mega-Arbel and Catalina pavers. These pavers are heavy and rigid, which is exactly why they telegraph a bad base. Over Frisco’s expansive clay, a base that was too thin or not compacted to spec lets units rock and dip. Walking on it sounds hollow; that’s the tell.
- Efflorescence and joint sand loss. The white haze on Belgard pavers is mineral salts migrating to the surface, and it shows up more where irrigation keeps the pavers wet. Loose joint sand follows the same pattern: water moves through, sand washes out, joints open, and the surface degrades faster.
- Weston Stone walls bulging or leaning. A retaining wall block wall without geogrid and proper drainage is a stack of blocks holding back wet clay. It leans, then it bulges. That’s a drainage and reinforcement problem, not a block problem.
- Fire pit mortar joints cracking. A Belgard Bristol fire pit kit set on an inadequate footing cracks at the mortar joints as the heat cycles through it. The fire pit is doing its job; the base under it isn’t.
- Drainage grading failures in newer subdivisions. Builders often left lots on expansive clay with minimal drainage grading, so water that should sheet away sits against a fresh slab, fence line, or patio edge. That’s when a hardscape that looked fine in year one starts moving in year three.
Belgard Parts & Our Repair-vs-Replace Approach
We choose parts by what the job actually needs. For visible Belgard units, we use Belgard components where they’re available so color and dimension match the field. For base, polymeric sand, and geogrid, we specify quality aftermarket material that meets or exceeds the manufacturer’s spec. We don’t claim to stock genuine Belgard parts, and we’re not a dealer; we source what fits.
Repair is the honest answer when the problem is isolated: one settled section, a failed joint, a single paver that’s rocking. Rebuild is the honest answer when the base failed broadly or a wall has moved. Patching a widespread base failure is money you spend twice.
We’ll walk the area with you, show you where it’s moving and why, and give you a written estimate either way. Call (833) 620-7367 to set that up. Estimates are free.
Our Belgard Service Process – Step by Step
A Belgard paver patio or driveway often starts rocking or showing joint sand washout because the base was too thin or not compacted to spec over Frisco’s clay. A qualified local pro typically pulls the affected units, re-excavates and re-compacts the base, resets the Belgard pavers with fresh polymeric sand, and checks slope for drainage before re-opening the area. That’s the pattern our process follows.
- 1
Diagnosis. We walk the surface, sound for hollow units, check joints and efflorescence, and look at where water goes. On a Weston Stone wall we check for lean, bulging, and what’s behind the wall.
- 2
Repair or install. We pull affected units, re-excavate and re-compact the base, reset Belgard pavers, and install fresh polymeric sand. New installs start with the base and drainage graded before a single unit goes down.
- 3
Test and check. We check slope and drainage, confirm joints are full, and make sure nothing rocks underfoot.
- 4
Warranty and documentation. We leave you with a written record of what was done and the materials used, so a future warranty conversation has something to stand on.
See the difference
Before
After
Before
After
Before
AfterBelgard Products We Service & Install in Frisco
We work with the Belgard systems that show up on Frisco properties most: paver patios and paver driveways, retaining wall systems, and fire pit kits. On the paver side, that means installs, resets, and joint sand work. On the wall side, that means repairs, reinforcement, and drainage corrections. On the fire feature side, that means footing and mortar joint work.
We also handle concrete driveways where paver work isn’t the right fit, and we’ll tell you if that’s the case for your property. Paver Patio Installation, Paver Driveway Installation, and Concrete Driveway Installation are the three services we’re asked for most in Frisco.

We Also Service These Brands
Belgard is one brand in a much wider set. We work across KraftMaid cabinetry, Cambria and Silestone surfaces, and Kohler fixtures when a project reaches inside the house, alongside other hardscape names. If your project spans more than one material category, you don’t have to coordinate three contractors to get it done. We spec the right brand for the job.
FAQs – Belgard Construction Service in Frisco
Is Construction Frisco authorized by Belgard? No. We are an independent Belgard service provider. We are not affiliated with, authorized by, or a dealer for Belgard, and we don’t claim to be. We install, repair, and service Belgard systems using quality parts that fit them.
Do you use quality parts that fit Belgard equipment? Yes. We use Belgard units and matching components where they’re available for color and dimensional consistency, and quality aftermarket base, polymeric sand, and geogrid that meet or exceed spec. We don’t claim to stock genuine Belgard parts. Call (833) 620-7367 to talk through your situation.
How long does Belgard service take? A single settled section or a joint sand refresh is usually a short job. A full paver patio or driveway install or a base rebuild takes longer, and the written estimate lays out the scope. Call (833) 620-7367 for a timeline on your project.
What kinds of Belgard products do you cover? Paver patios and driveways, retaining walls, and fire pit kits, including Mega-Arbel and Catalina pavers, Weston Stone walls, and Bristol fire pit kits. Call (833) 620-7367 to confirm yours.
Will service void my Belgard warranty? It shouldn’t if the work is done to spec. Pulling and resetting pavers over a properly re-compacted base keeps your original Belgard material in place, which is the warranty-safe approach. We’ll tell you before work starts if a repair could affect coverage. Call (833) 620-7367 for a free estimate.
How much does Belgard construction cost in Frisco? Typical estimated ranges are below. The written estimate sets the final price.
| Service | Typical Estimated Range |
|---|---|
| Paver Patio Installation | $3500 – $11000 |
| Paver Driveway Installation | $7000 – $18000 |
| Concrete Driveway Installation | $4500 – $12000 |
Call (833) 620-7367 for an exact quote. Estimates are free.
Can Belgard pavers be installed over the expansive clay soil common in Frisco? Yes, but only with a base built for it. Frisco’s black clay expands and contracts hard through wet springs and drought summers, so the base has to be excavated to depth, compacted to spec, and graded for drainage. Skip that and the pavers will rock within a season or two.
Why does my Belgard paver patio have white haze and loose joint sand? The haze is efflorescence, mineral salts migrating to the surface where irrigation keeps the pavers wet. Loose joint sand means water is moving through and washing it out. Both point at drainage and joint maintenance, and both are fixable. Call (833) 620-7367 for a free estimate.
Is a Belgard Weston Stone retaining wall safe to repair or does it need a rebuild? If it’s leaning or bulging, get it looked at before it moves further. A minor lean can sometimes be corrected with drainage and reinforcement; a wall that’s already bulging usually needs a rebuild with geogrid and proper drainage behind it. Call (833) 620-7367 and we’ll tell you which one you’re looking at.
How soon can I use a Belgard paver driveway after installation? Foot traffic usually comes first, and vehicle traffic waits until the base and joint sand have settled. Polymeric sand needs to cure before it gets wet. We’ll give you a specific window with your written estimate. Call (833) 620-7367 to schedule.
Do Belgard fire pit kits need a concrete footing in North Texas? Yes, in practice. A fire pit kit set on an inadequate footing cracks at the mortar joints as heat cycles through it. A proper footing keeps the kit stable through those cycles. Call (833) 620-7367 for a free estimate.
Book Your Belgard Service in Frisco, TX
Whether your Belgard patio is rocking, your Weston Stone wall is leaning, or you’re planning a fresh paver driveway on a lot that’s still being finished around you, we’ll walk it with you and give you a written estimate. Call (833) 620-7367. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. Estimates are free.
Written by the team at Construction Frisco.