Windows & doors
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Trusted Windows & Doors for Frisco Homeowners
If your windows fog up between the panes, whistle on a windy day, or stick so badly you skip opening them, the glass has done its job longer than expected. In Frisco’s new-build neighborhoods, builder-grade windows and patio doors often start losing their seal within the first decade, and the heat load on a west-facing wall makes it worse. Our technicians have up to 11 years of experience installing and replacing windows and doors of every type, and we work with brands like PGT and Therma-Tru so the fit and finish match your home’s structure and weather demands. Call (833) 620-7367 to schedule a free estimate. We answer 24/7, and same-day options are available for scheduled work.

What Our Windows & Doors Service Includes
Window Installation
Window installation covers setting brand-new units into new frames, whether that’s a new wall opening or a full frame replacement. You need this when you’re adding onto the house, building out a room, or replacing a window whose frame is beyond repair. We measure the opening precisely and specify the right PGT or CWS unit for that exposure, then flash and seal it so water moves away from the frame instead of into it.
Door Installation
Door installation means fitting a brand-new door into a prepared or existing opening, including entry doors, back doors, and interior doors. If your current door is warped, cracked, or no longer closes flush with the weatherstripping, a fresh install restores a tight seal and a reliable lock line. We work with Therma-Tru door systems and set the frame plumb and square so the door swings true and latches without a shove.
Window Replacement
Window replacement swaps out old glass and frames for new units while keeping the opening in the wall. It’s what you need when your windows are drafty, hazy, or have failed seals but the rough opening itself is fine. We pull the old unit cleanly, check the framing for water damage, and install a new window sized to the opening – no cutting corners on flashing or insulation.
Impact Windows & Doors
Impact windows and doors use laminated glass and reinforced frames designed to hold a barrier against flying debris and high wind pressure. In Frisco, where spring and early summer storms roll in quickly, these products offer meaningful protection and reduce the risk of wind-borne glass. We offer impact-rated options from PGT, CGI, and ECO Window Systems and match the product to your home’s exposure rather than applying one solution everywhere.
Energy-Efficient Windows
Energy-efficient windows pair low-E coatings and gas fills with frames that limit heat transfer. If your south- or west-facing rooms blister in July or your utility bills creep up without explanation, better glazing can cut the heat load. We help you choose the right combination of coating and frame material for each face of the house, so the whole envelope performs as a system.
Sliding & Patio Doors
Sliding and patio doors connect indoor living to a patio or covered porch, and they take more wear than any door in the house. When the track wears down, the glass fogs, or the door no longer pulls a tight seal, replacement restores both function and security. We install sliding glass doors and impact sliding glass doors from brands including CGI and CWS, with attention to the sill and threshold so water sheds correctly.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Brands We Service for Windows & Doors
We work with PGT windows and doors often enough to know where these units wear first – the weatherstripping at the lock rail, the felt on patio door tracks, and the caulk line where the frame sits against the rough opening. If your PGT windows are older and starting to lose their seal, we can tell you quickly whether replacement is due or whether the hardware and seal are all that need attention. PGT’s aluminum and vinyl lines both show their own patterns, and we account for those when we spec a replacement.
CGI and CWS are the other two brands we’re most familiar with in North Texas. CGI units are common on homes built in the last decade, and their sliding glass doors are a frequent focus when the track begins to bind. CWS windows we see on both existing homes and new construction, and their hardware and gaskets are worth checking before you commit to a full replacement. Whether you have a PGT unit or any other make, we can help – just call (833) 620-7367 and we’ll come out to take a look.
Signs You Need Windows & Doors Right Now
- Fog or condensation between the panes. That haze is a failed seal, and the window has lost its insulating gas. It won’t clear on its own and will only get worse through the cooling and heating cycles of a Frisco summer.
- Drafts near the window frame. A whistling window means air is passing where it shouldn’t. It raises your energy bill and lets in dust, moisture, and pollen; replacement or a fresh weather seal fixes both.
- A door that sticks, sags, or won’t latch. This usually points to a frame that’s out of square or a hinge that’s pulled loose. Left alone, the door can split or the lock line can fail, which is a security problem.
- Water stains or soft wood around a frame. This is the sign we take most seriously. Water behind the frame is already working on the structure; the sooner it’s addressed, the less damage it does.
- Glass that cracks or doesn’t seal tightly. In impact-rated units or doors with a compromised seal, this means the protection is compromised too. Replacement is the only way to restore the rated performance.
Our Windows & Doors Process – Step by Step
- 1
Free on-site estimate. We visit the home, measure every opening, and note which windows or doors need a full replacement versus a repair. You get a written line-item estimate, so you see exactly what each opening costs before any work is scheduled.
- 2
Product selection. We sit down with you and walk through the brands and configurations that fit your structure and your budget. PGT, CGI, and Therma-Tru all have different performance profiles, and we match the right one to each opening rather than applying a blanket solution.
- 3
Measurement and ordering. Once you approve the products, we take final measurements and place the order. Custom and geometric windows take longer than standard sizes, and we tell you the expected lead time upfront so there are no surprises.
- 4
Installation. Our technicians remove the old units, inspect the rough opening and framing for rot or water damage, and flash and seal each new unit before setting it. The same care goes into alignment and hardware as goes into the glass itself.
- 5
Final walkthrough. We show you every opening we touched, demonstrate the locks and the sliding mechanisms, and confirm the seal and operation. The written estimate is the final price – there are no change orders once the work starts.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Windows & Doors Cost in Frisco?
Window and door work in Frisco falls into two rough categories, and the size of the job drives the number far more than the brand. For a full replacement of several windows across a home, a typical estimate runs $4,500-$15,000 depending on the number of openings, the size of each window, and the frame material. Impact window installation – which adds laminated glass and heavier frames – typically runs $8,000-$25,000 for a whole-home or large multi-opening project. A single door install sits at the lower end; a full impact sliding glass door runs toward the higher end.

Several factors move the price up or down: the number of units, whether the opening is standard or custom (geometric and odd-shaped windows cost more), and the level of impact rating. West- and south-facing walls may justify a higher-rated product, while shaded openings can use a more economical unit without sacrificing performance. To avoid overpaying, compare the written line-item estimate, not just the bottom line – check what’s included for flashing, sealing, and haul-away. We don’t charge extra for those; they’re part of the install. A free estimate from us includes the measurement, the product recommendation, and the line-item pricing, so you can compare apples to apples. Call (833) 620-7367 for an exact quote – estimates are free.
Windows & Doors Near Frisco – Our Service Area
We serve homeowners in Frisco and nearby communities including Little Elm, The Colony, Paloma Creek South, Providence Village, Lewisville, Carrollton, Addison, Corinth, Highland Village, Farmers Branch, and Coppell. Appointments are easy to schedule in the cities closest to Frisco, and our team plans the visit so you’re not left waiting around. We also handle broader work through Construction Frisco, which covers the full scope of residential projects if your windows and doors are part of a larger renovation. Fast dispatch is available from 7am to 7pm, Sunday through Friday.
Serving Frisco, TX – Our Local Coverage Area
We serve Frisco and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Windows & Doors in Frisco
Windows & doors service covers the installation, replacement, and repair of windows, entry doors, patio doors, and specialty units like impact windows and geometric windows. We handle the full job: measuring, ordering, removing old units, flashing and sealing new ones, and cleaning up afterward. It’s one trade category handled by one accountable team, so you don’t manage separate installers for glass and doors. Call (833) 620-7367 for a free estimate.
Most residential jobs take one to three days, depending on the number of openings and whether we’re replacing windows or a door. A single door install is usually a day; a whole-home window replacement with four to six openings typically runs two to three days. Custom geometric windows and impact units can take longer because of product lead times. We give you a realistic schedule in the estimate, and we stick to it.
A typical window replacement in Frisco runs $4,500-$15,000 depending on the number of openings and the unit type. Impact window installation for a larger project typically runs $8,000-$25,000. The written estimate sets the final price, and it’s free. Call (833) 620-7367 for an exact quote.
Yes – PGT is one of the brands we work with most often. We know where PGT units tend to wear first, from the seals to the hardware, and whether the fix is a repair or a full replacement. We can source new PGT units in the right configuration for your opening. If you have a PGT window or door you’re concerned about, call us and we’ll take a look.
We offer same-day service for scheduled work. We answer 24/7. Fast dispatch is available from 7am to 7pm, Sunday through Friday. A call outside dispatch hours is booked into the next opening. Saturday is closed. Call (833) 620-7367 for the next available estimate slot.
Our workmanship is backed by a workmanship warranty, and the products carry their own manufacturer warranty. The specific terms depend on the brand you choose – PGT, CGI, and Therma-Tru each have their own warranty language. We walk you through what’s covered before you sign the estimate, so you know exactly what you’re getting. Call (833) 620-7367 with any warranty questions.
Clear the area around each opening, and move furniture and wall hangings away from the work zone. We handle the removal and haul-away of old units, and we lay drop cloths before we start. Trim and casing may need to come off during the job, and we’ll tell you which ones. Call (833) 620-7367 when you’re ready to schedule.
Schedule Your Windows & Doors Service in Frisco Today
Foggy windows and sticking doors won’t fix themselves, and a free estimate is the quickest way to know what you’re dealing with. Call (833) 620-7367 to schedule yours. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday. You’ll get a written line-item quote and a fixed price with no change orders. There’s no obligation – just clear answers.
Written by the team at Construction Frisco.